Where Is The Reset Button On Blink Camera?

A red light on the Blink XT2 indicates that the camera is not connected to the internet.

If the camera flashes Red LED 5 or 6 times after the Blue recording light goes out, this indicates faulty batteries.

Please make sure you have fresh AA Lithium non-rechargeable batteries installed..

Hello! Blink cameras cannot function without an active WiFi connection or an online Sync Module. … Blink cameras cannot function without an active WiFi connection or an online Sync Module. If internet connectivity is lost or if the Sync Module is powered off, the system will go offline until it both are restored.

Select the system that contains the Sync Module you want to remove. Tap on Sync Module. Choose “Delete Sync Module” and then OK. Scan or enter in the serial number of the Sync Module, located on the bottom of the unit and confirm once again that you would like to delete it from your account.

First, use a thin object to press and hold the reset button until you see a red light. The reset button is located on the right-hand side of the Sync Module next to the USB port. Please note that this could take between 15-30 seconds. This will cause the Sync Module to reboot into setup mode.

Once you’ve connected to the Blink-#### network, go back to the Blink app by double tapping your home button and tapping Blink. The app will pull up a list of available WiFi networks. Locate and tap your home WiFi network. Carefully enter your WiFi password and tap Join on your keyboard.

If you receive a “Camera Offline” notification that “Your Blink Mini is offline”, it means the Blink servers no longer have communication with the camera. … The first, is to check the Wi-Fi internet and the power supply, then check the camera power connection. Troubleshooting: Check Wi-Fi.

The Blink cameras do not offer continuous recording, though you can leave the system armed for motion detection for any interval of time.

Try illuminating the scene, at night, so that the camera thinks it’s day, and see if the live view fails. If it fails then, when not trying to use the IR illuminator, then your issue is likely something other than the camera, because it won’t even know that it is night, if the scene is well illuminated.

If the Sync Module is not connecting to your Wi-Fi network, it is easiest to follow this troubleshooting step as detailed here : Reboot the Wi-Fi router and wait for internet connection. Reboot the Sync Module (short press the reset button).

II. Setting up the Sync ModuleOn the Home screen Tap the Blink + icon to begin.Tap the first Blink wireless camera system option. … Next a screen will prompt you to scan the QR code or manually enter the serial number on the device.Give your system a name such as “Home” or “Office” and then tap Done.More items…

The Sync Module has a physical reset button located next to the USB port on the side of the device (pictured below). This button should only be used to put your Sync Module into setup mode. Pressing this button will bring your system offline until you reconfigure your Sync Module.

If one of your Blink cameras isn’t responding, you may see error messages like “Camera Busy” or “Thumbnail Failed”. … Wait two minutes for Internet service to be restored, then try using your camera again. Power cycle your camera. To do this, remove the batteries for 10 seconds and reinsert them.